![]() ![]() Check your Honda owner’s manual for more information. If there is damage to the pan, you should replace it entirely. Possible causes of the leaks could be issues with replacing the pan bolts or pan gasket. If there are any leaks, getting back under the hood and correcting them is essential. You can test if there are any leaks by putting cardboard underneath and leaving the car running for a bit. Manufacturers recommend repeating this process up to three times, ensuring the oil has traveled through the transmission hose, valve body, and converter.įinish the process by checking for any transmission fluid leaks. Confirm that the transmission liquid is at the correct levels using the dipstick. Switch the Honda back on and let it run for a few minutes. Use a funnel to refill the transmission liquid to avoid any spillage. We also love to use this Automatic Transmissions Kit, which makes it quick and easy to refill it. You will spot a red dipstick, which is where the transmission fluid port is located. Reposition your vehicle back on the ground again and open its hood. Tightening the bolts too much can lead to warping and cracking, which can damage the pan. Align the pan according to the bolts and fit them snuggly using a wrench. The filter might also require replacement. The owner’s manual recommends replacing the aluminum crush washer to prevent leaks. Inspect the magnet on the drain plug if necessary, you can change it. It is normal to spot small pieces of metal shavings however, bigger ones could indicate a problem and a need to take your vehicle to a Honda Service Center. Check the drain pan for large pieces of metal shavings. Completely free the pan until it has all run out. Loosen the drain plug with a 1 cm ratchet and put the drain container below to catch the used transmission fluid. If there is no drain plug, find a container the size of the pan to empty the fluid. The pan can have a drain plug, so you don’t need to undo the whole pan. The pan is located on the lower side of the transmission with six to eight bolts, so it’s pretty easy to spot. ![]() Locate the drain plug on the plastic pan under the front bumper. We also advise letting the cars cool down for about 10 minutes. Steel wheel ramps would do the trick too. Add wheel chocks to stop it from moving while you are at work. We recommend that you use jacks to elevate it. Park your Honda on a flat surface with a parking brake on and switch it off. One change will require approximately 3,000 ml (3l or 3.3 US quarts). The ATF-DW1 is specially designed to meet Honda’s quality standards. Make sure you have gloves and safety glasses. The first step is to purchase transmission fluid and safety gear. ![]() Steps for Honda transmission fluid change If the transmission fluid is brown, it’s time to change it. Use a clean rag to wipe the transmission dipstick and replace it. If the transmission’s fluid is brightly colored pink or looks clean, but fluid level level is low, you can add more fluid. The transmission dipstick is red-handled, and you will spot it under the hood. It should be part of the regular maintenance. Alternatively, you can check the state of the transmission’s fluid by yourself. DIY Honda Transmission Fluid ReplacementĬheck your car’s owner’s manual to see when you are due for a transmission fluid replacement. Draining the transmission fluid takes around 30 minutes. It is advisable to visit your local Honda Service Center for a Honda transmission fluid flush. It will make for smoother shifts and the most important reason is it will extend the life of your transmission. Transmission fluid replacement is a maintenance service you should perform every 50,000 to 100,000 miles for your Honda. ![]() You can either drain or flush the transmission fluid however, we recommend draining it. A Honda transmission fluid change needs to take place every 50,000–100,000 miles. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |